Dunlop Floor Tile Adhesive is a high-performance, general-purpose adhesive suitable for ceramic, porcelain, mosaic, and some natural stone tiles (excluding moisture-sensitive stones). It can be used on cement screeds, concrete, and compressed fibre-cement sheets for both indoor and outdoor flooring.
 

DUNLOP FLOOR TILE ADHESIVE is a versatile general-purpose adhesive designed for fixing a range of floor tiles, both indoors and outdoors. It adheres well to surfaces like concrete, compressed fibre-cement sheets, cement screeds, and existing tiles. For timber floors or areas with potential movement, use DUNLOP WALL AND FLOOR TILE ADHESIVE instead.

SUBSTRATES

• Concrete
• Cement screeds
• Compressed fibre-cement sheets
• Existing ceramic tiles (indoors only)

TILE TYPES

• Ceramic
• Porcelain
• Natural stone (excluding moisture-sensitive varieties)
• Mosaics
• Fully vitrified and translucent tiles

COLOUR: Grey

SURFACE PREPARATION

Ensure the surface is consistently flat, firmly fixed, and free of dust, oil, grease, or other contaminants. All surfaces must be clean and dry with no residual moisture or permanent dampness. Prime porous substrates with DUNLOP PRIMER & ADDITIVE or DUNLOP MULTIPURPOSE PRIMER.

Concrete Floors

Concrete must have a wood float finish and be fully cured (min. 4 weeks). Screeds should be at least 7 days old. Remove sealers, curing compounds, or any laitance by mechanical means. Roughen steel trowel finishes to ensure bonding.

Cement Screeded Floors

Ensure screeds are properly cured and level, finishing with a wood float. New screeds must cure for at least 7 days before tiling.

Compressed Fibre-Cement Sheets

Install according to the manufacturer's instructions, ensuring the surface is clean. Priming is recommended.

Existing Tiles (indoors only)

Ensure tiles are stable and roughen their surfaces by mechanical means, removing at least 80% of the glaze.

MIXING

Mix the adhesive by adding powder to water. Use approx. 400ml of water per 1kg of powder. Stir to a thick, creamy consistency using a mechanical mixer, let stand for 5 minutes, and re-stir. The mixture is usable for 2.5 hours depending on temperature.

APPLICATION

Tile installation should comply with AS3958.1 standards. Use a notched trowel (10mm for floors) to apply. Spread adhesive over 1m² sections to avoid skinning before tile bedding. Ensure full coverage by pressing tiles at right angles to the adhesive. Large tiles or those with deep keys may require back buttering.

Remove excess adhesive from joints and surfaces before the adhesive sets. Allow at least 24 hours for the adhesive to cure before grouting.

DRYING TIMES & GROUTING

Grouting can begin after 24 hours at 23°C and 50% humidity. For larger tiles or humid climates, extend drying time. Use DUNLOP COLOURED GROUT or DUNLOP WIDE JOINT GROUT for joints wider than 8mm.

MOVEMENT JOINTS

Follow AS3958 standards for movement joints. Ensure joints are present at 3–5m intervals and around the perimeter. Keep joints approx. 6mm wide and fill with a flexible material like DUNLOP COLOURED SILICONE.

COVERAGE

Coverage varies based on substrate and trowel size:

• 10mm trowel: approx. 0.4m² per kg

For example:

• 4kg covers approx. 1.6m².

CLEAN UP

Clean tools and spills with water immediately after use.

SHELF LIFE

12 months if stored in original, unopened packaging at 23°C and 50% relative humidity.

PRECAUTIONS

• Not suitable for continuous immersion (e.g. pools). Use DUNLOP TILE-ALL for these applications.
• Avoid use on timber or non-absorbent substrates (e.g. metal).
• Ensure proper PPE is worn during preparation and application.