PC-Concrete ™ Anchoring and Crack Filling Epoxy— is the epoxy chosen to repair cracks in a warehouse and factory floors. Dispense and apply using a standard size caulking gun. Cures hard enough to drive over within 3 hours at standard temperature. Nothing stronger for your anchoring applications. PC-Concrete™ is a two-component (1:1 ratio), 100% solids, high modulus, and structural epoxy paste. PC-Concrete™ is a solvent-free, no odour, high strength, moisture insensitive epoxy system. The resin and hardener are uniformly dispensed from a 9-ounce cartridge system and mixed through a mixing nozzle using a standard size caulking gun. (We recommend at least an 18:1 thrust ratio). PC-Concrete™ is also provided in a 22-ounce dual cartridge system for Contractors and Professionals. This size requires a 600ml high thrust dual cartridge dispensing gun. For filling larger cracks and cavities use the 102-ounce bulk kit. PC- Concrete™ will NOT SHRINK. Suitable for Interior and Exterior applications. Can be applied to WET & UNDERWATER surfaces.

Here are just a few specific uses (there are many other uses):

Anchor into marine docks above or below waterline
Anchor equipment to floors
Bond to pre-stressed floors
Anchor into stone and rock.
Install anchor bolts for sill plates
Anchor into foundations and block
Fill cracks in concrete allowing equipment traffic In 4 hours
Anchor into concrete railroad ties
Anchor HVAC equipment to concrete pads and roofs
Waterproof floor to wall cracks
Re-anchor railing at convention center or apartment building
Anchor seats in lecture hall or theaters
Repair broken concrete in shopping mall parking garage
Fill spalled concrete in car wash
Fix fork truck damaged concrete in warehouse
Seal crack in sanitation and chemical storage facility containment area
Repair floor in fire station garage
Anchor safe to floor prison and security pickproof epoxy
Anchor machinery