Key Features

• UV and weather resistant
• Superior waterproof seal - superior adhesion and resistant to lifting, provides a long-lasting, flexible seal
• Non corrosive neutral cure formula
• Has superior flexibility +/- 25% movement capability
• Temperature resistance - approximately -60°C +150°C
• Suitable for contact with drinking water - complies with AS/NZS 4020#
• 25 year guarantee* against crumbling, cracking and peeling away

Selleys Roof and Gutter Silicone is a neutral cure (non-corrosive) 100% silicone sealant suitable for most building surfaces including metals, tile, cement sheeting, PVC and Colorbond® roofing. It is available in a variety of colours, including a range of Colorbond(R) matches, to suit your roof and gutters.

Where can this product be used?

• Metal and tile roofing
• All metal lap-joint waterproofing
• Colorbond roofs and fences
• Guttering and flashings
• Vents and downpipes
• Weatherproofing caravans and trucks
• Copper, brass and zinc
• Skylights

What materials is this product suitable for?

• Aluminium
• Sheet Metal
• Copper
• Brass
• Zinc
• Galvanised Metals
• Rigid PVC and most plastics including polystyrene
• Rubber
• Glass
• Terracotta
• Concrete
• Glazed tiles
• BlueScope Steel decorative sheet metals such as Lysaght Zincalume and COLORBOND

How to Use

Use in a well ventilated area. Avoid contact with skin and eyes.

1. Thoroughly clean and dry surface from oil, dirt and grease with mineral turps.
2. Cut the seal at the top of the cartridge and cut the nozzle at a 45° angle, to the size of the gap opening. Fit the nozzle to the top of the cartridge and insert the cartridge into a caulking gun such as Selleys Light Speed Caulking gun.
3. Hold the caulking gun at a 45° angle and gun sealant ahead of nozzle ensuring product is pushed into joint.
4. For a smooth finish, tool with a spatula dipped in soapy water. Clean up before sealant skins in 5-10 minutes, with a cloth dampened in mineral turps.
5. Sealant will cure in 72 hours. At this point any unneeded sealant can be removed by trimming with a sharp blade, but avoid under-cutting the seal.

Limitation:

• Not paintable. Complete painting 7 days prior to applying sealant.
• Not recommended for use as a plug for burst pipes.
• Do not use in below waterline applications.
^Not for use on polyethylene, polypropylene or Teflon - pre-test plastics before use

Handy tips

• For neater joints, mask sides before applying sealant and remove tape before sealant skins.
• When first applying product, extrude a small amount onto a piece of scrap material to ensure a smooth continuous flow of silicone sealant.
• For a better finish use a spatula dipped in mineral turps or soapy water to tool off the sealant.
• Work in sections that can be completed before sealant skins. Tooling off and tape removal must be completed before skinning occurs or a rough surface may result, so working in sections allows for a better finish.
• If there is old silicone which needs to be removed, we recommend using Selleys Silicone Remover, this ingenious product makes removing old silicone easy.

*Warranty Information

* Refer to product label for full conditions. This guarantee does not limit and may not necessarily exceed your rights under the Competition and Consumer Act 2010.

Clean up

• Uncured product may be removed with mineral turps.
• Cured product can be removed with Selleys Silicone Remover or by cutting and scraping.