Dulux Precision Maximum Strength Adhesion Primer
Get a tough, reliable bond on hard to paint surfaces with Dulux Precision Maximum Strength Adhesion Primer. This water based, low odour primer works as a primer, sealer and undercoat, creating a strong foundation for acrylic or oil based topcoats on both interior and exterior projects.
Why choose this primer
- Water based with low odour
- Excellent adhesion on glossy and hard to coat surfaces
- Suitable as primer, sealer and undercoat
- Interior and exterior use
- Fast drying: touch dry in 30 minutes, recoat in 1 to 2 hours
- Topcoat within 30 days for best results
Ideal surfaces
Tiles, high gloss enamels, varnished timber, uPVC, fiberglass, aluminium, galvanised steel, Colorbond, glass, glazed brick, laminates and previously painted glossy finishes.
Key specs
| Finish |
Flat |
| Colour |
White |
| Coverage |
Up to 10 m² per litre per coat, depending on surface |
| Dry time |
Touch dry 30 minutes |
| Recoat time |
1 to 2 hours |
| Full strength |
7 days after application |
| VOC |
30.4 g/L |
| Application temperature |
Between 10°C and 32°C |
| Clean up |
Water |
| Pack sizes |
1 L and 4 L |
How to use
- Prepare the surface so it is clean, dry and free of grease, wax, dust, loose paint and rust. Wash if needed and allow to dry.
- Stir thoroughly before and during use.
- Apply 1 even coat with a high quality brush, roller or spray. For very smooth surfaces 1 coat is usually sufficient.
- Allow 1 to 2 hours before recoating or applying the topcoat. Topcoat within 30 days.
Application tips
- Do not tint for difficult surfaces. Thin only if necessary with a small amount of water.
- When using solvent based enamel topcoats, lightly sand the primer before applying the enamel.
- If using under products with strong solvents, let the primer dry 24 hours and test compatibility on a small area first.
Where not to use
- Floors, benchtops or surfaces subject to standing water
- Below 10°C surface temperature or if conditions may drop below 10°C during drying
Clean up and safety
Clean tools with water and a mild detergent, then rinse. Ensure good ventilation during use. Wear eye protection and avoid skin and eye contact. Always follow label directions.
