Description
Selleys Araldite Ultimate Bond is a grey two-part epoxy adhesive engineered for the most demanding repairs, delivering a durable, long-lasting bond that holds up to 200kg/cm² when fully cured on stainless steel. It is the toughest of the Araldite range, designed to be tug and snap proof for fixes that need to stay put.
About this adhesive
Two-part system of resin (Part A) and hardener (Part B) mixed in a 2:1 ratio.
Bonds a wide range of surfaces with a strong, rigid, durable join.
Sets in around 5 minutes and is touch-firm fast, with a low-odour formula.
Made from 20% bio-based carbon.
Working (usable) time of roughly 3-4 minutes at 20°C, so mix only what you can apply.
What it bonds
China, ceramic and porcelain
Metal
Glass
Leather (pre-test for compatibility)
Rubber (pre-test for compatibility)
Wood and timber
Most rigid plastics
Where to use it
Indoor: repairing crockery, ornaments and ceramics, refitting loose furniture joints, bonding metal, glass and timber components, and general household fixes.
Outdoor: durable repairs on tools, garden and workshop items where a tough, weather-durable bond is required. Bond strength depends on substrate, bond size and surface preparation, and set times lengthen in colder weather.
How to use it
1. Abrade, clean and dry both surfaces so they are free of dust, grease and loose oxides.
2. Snap the cap from the plunger and carefully cut the sealed tips at the end of the nozzle.
3. Apply even pressure to the plunger to dispense both liquids onto a clean disposable surface (2:1 ratio) and mix thoroughly with a spatula.
4. Apply the mixed glue to both surfaces, then bring them together.
5. Hold in place with tape or weights if needed and avoid undue strain on the joint for at least 60 minutes. Cures in 24 hours; maximise the bond area (minimum 2.25cm²) for best performance after full cure.
Replace the cap on the nozzle for storage and clean up any uncured adhesive with acetone.
Important notes
Will not bond PTFE, polyethylene or polypropylene plastics.
Bond will soften above 60°C but strength is restored once the temperature returns to normal.
May discolour if exposed to UV. Full cure takes more than 72 hours.
Not recommended where a clear, invisible bond is required, as the cured adhesive is grey.
Specifications
| Brand |
Selleys Araldite |
| Product |
Ultimate Bond Epoxy Adhesive |
| Technology |
Two-part epoxy |
| Colour |
Grey |
| Size |
30mL |
| Mix ratio |
2:1 (Part A : Part B) |
| Working time |
Approx. 3-4 minutes at 20°C |
| Set time |
Approx. 5 minutes |
| Cure time |
24 hours (full cure >72 hours) |
| Holds |
Up to 200kg/cm² on stainless steel when fully cured |
| Heat resistance |
Softens above 60°C, strength restored on cooling |
| Clean up |
Acetone (while uncured) |
Safety
Danger. Part A causes skin and serious eye irritation and may cause an allergic skin reaction. Part B may be corrosive to metals, causes severe skin burns and eye damage, and may cause an allergic skin reaction. Do not swallow and avoid contact with skin and eyes. Wear eye protection and protective gloves when mixing or using, and avoid breathing dust, vapours or spray. Keep out of reach of children and keep in the original packaging. If medical advice is needed, have the product container or label at hand. Refer to the Safety Data Sheet for full handling information.
