Description
Bostik Contact Bond is a solvent based, high solids, brush or scaper grade contact adhesive. It is specifically formulated to provide an extra-strong and flexible bond on contact.
Where to Use
Residential
Commercial
Substrates
Brush or Scraper
Furniture and allied industries for fixing plastic laminates
Flexible decorative surface coverings
Materials
Neoprene rubbers
Porous and non-porous surfaces
Wood
MDF
Particleboard
Plywood
Leather
Felts
Cottonback
PVC
Metal
Features
n-Hexane formula
Safe quick drying
Heat and water resistant
Good brushability
Excellent adhesion to porous and non-porous surfaces
Provides an extra strong and flexible bond on contact
Uses
Bostik Contact Bond is a solvent based, high solids, brush or scraper grade contact adhesive. It is specifically formulated to provide an extra-strong and flexible bond on contact. It resists heat and water. It also provides excellent adhesion to most natural and neoprene rubbers as well as a wide variety of porous and non-porous surfaces. It may be easily applied by brush or scraper giving a secure and lasting bond making it clean and economical to use.
Bostik Contact Bond is primarily used in the furniture and allied industries for fixing plastic laminates and rigid or flexible decorative surface coverings to wood, MDF, particle board, plywood, leather, felt, cotton back PVC and metal.
PRODUCT CHARACTERISTICS
Colour Pale yellow
Viscosity Medium syrup
Composition Polychloroprene
rubber/resin
Coverage 5 to 6m² per litre
TYPICAL PERFORMANCE DATA (approx.)
Touch dry Tube: 5 to 15 minutes
Can: 20 to 30 minutes
Full cure 45 minutes
Solids content 22%
Specific gravity 0.83
Heat resistance > 150°C
DIRECTIONS FOR USE
Read and understand the Safety Data Sheet before using this product. SDS can be acquired by visiting www.bostik.com.au or by scanning the relevant QR code on the pack.
SURFACE PREPARATION
Ensure all surfaces are clean and dry and free from all loose paint, dust, grease, oil and foreign materials.
APPLICATION
Tube (Blister Pack) Application
1. Unscrew cap and pierce and of the tube with the reverse end of the cap
2. Apply thin, even film to both surfaces to be glued
3. Leave until touch dry (approximately 5 to 15 minutes), then bring both surfaces together accurately
4. Take care to avoid the formation of air bubbles between surfaces
5. To ensure maximum adhesion, clamp or weigh down the entire surface or apply firm hand pressure evenly
6. Replace screw cap to keep the contents of tube airtight
CLEANING
To clean up tools, equipment and adhesive spills use Mineral Turpentine. Use Bostik Handy Wipe towels to remove adhesive from the skin.
STORAGE AND SHELF LIFE
Store in a cool dry place between 5°C and 30°C and out
of direct sunlight. Keep away from sources of ignition.
Shelf life is 12 months from the date of manufacture
when stored as directed.
VOC INFORMATION
606g/litre
