High strength, water based adhesive for carpet and cork
Dunlop Multipurpose Carpet & Cork Adhesive is a water based, high strength adhesive designed for installing smooth or textured backed carpets and cork tiles. It delivers excellent wet grab and reliable bond on prepared subfloors.
Suitable Surfaces
- Concrete
- Marine plywood
- Fibre cement sheet
Key Features
- Water based and low odour
- High initial grab for reduced slippage
- Repositioning window up to 60 minutes
- Install immediately into wet adhesive for most carpets
- For cork or stiff backings, allow 10 to 15 minutes tack time before laying
Coverage
- Approx. 2.5 m² per litre with a 3.2 mm V notch trowel
- Approx. 3.5 m² per litre with a 2.4 mm V notch trowel
Application
- Ensure subfloor is dry, smooth, clean and protected from moisture. Prime highly porous concrete or timber before applying.
- Spread an even coat with the recommended V notch trowel.
- Lay carpet into the wet film. For cork or stiff backings, wait until the adhesive becomes tacky.
- Roll in both directions with a suitable drum roller to ensure full transfer.
Set and Traffic Times
- No foot traffic for 24 hours
- Heavy traffic after 48 hours
- Avoid water and cleaning for 48 hours
Clean Up
- Clean tools immediately with warm soapy water
- Remove dried residue with mineral turps
Storage
Shelf life up to 12 months in an unopened container stored at around 23°C.
Good To Know
Apply between 10°C and 30°C. Coverage varies with subfloor condition and trowel technique.
