Dunlop Ready-To-Go Vinyl Flooring Spray Adhesive is a fast and tidy spray-on adhesive for installing vinyl sheet, vinyl tiles, and vinyl planks with vinyl backing over concrete, underlayment grade plywood, metal, and fibreglass. It delivers an even spray pattern, strong bond, and immediate traffic readiness once rolled.
Why choose this adhesive
- Quick, clean spray application that saves time
- High initial grab for reliable placement
- Dry to touch in about 10 to 40 minutes
- Up to 3 hours open time once tacky
- Ready for immediate foot traffic after rolling
- Heat weld flooring 1 hour after installation
- Suitable with underfloor heating systems
- Water based acrylic blend with very low odour
Suitable substrates
Concrete, underlayment grade plywood, metal, and fibreglass. Use on vinyl-backed sheet, tiles, and planks.
Not suitable for
Cushion-backed flooring products.
Surface preparation
- Ensure the substrate is flat, dry, and free from dust, oil, paint, old adhesive, wax, curing compounds, sealers, and hardeners.
- Lightly damp-mop concrete to remove fine dust before application.
- Correct surface imperfections before installation to avoid telegraphing.
How to use
- Ventilate and mask the area to protect adjacent surfaces from overspray.
- Shake the can well and remove the blue safety tab.
- Hold the can upright 50 to 76 cm above the substrate and spray in smooth, even passes to achieve a uniform frosted look.
- Avoid heavy patches and overspray. Lightly re-spray missed areas if needed.
- Allow to dry until no adhesive transfers to the fingertips.
- Lay the vinyl and roll firmly within 1 hour using a suitable heavy roller to ensure full contact.
- The floor is ready for immediate use once rolled. Heat welding can commence after 1 hour.
Key technical data
- Chemical type: water based acrylic blend
- Dry to touch: approximately 10 to 40 minutes
- Open time after tack: up to 3 hours
- Traffic allowance: immediate after rolling
- Underfloor heating: compatible
- Appearance when sprayed: milky white frost
Storage and safety
- Store between 10°C and 50°C. Avoid freezing and direct sunlight.
- Pressurised dispenser. Do not pierce or burn the can, even when empty.
- Use in a well ventilated area and avoid contact with eyes and skin.
Tip: Wipe any overspray from adjacent surfaces with a damp cloth before it dries.
