Overview
LOCTITE Super Glue All Plastics is a rapid dual-action adhesive kit featuring a precision super glue and a surface activator pen. Engineered to bond difficult plastics such as polyethylene (PE), polypropylene (PP) and PTFE, it forms clear, resilient bonds in seconds and resists water, most household chemicals and freezing temperatures. Ideal for repairs on toys, cameras, small automotive parts, wiper blades, rubber seals, figurines and other plastic components.
-
Advanced bonding system: activator primes the surface; glue delivers high strength.
-
Fuses hard-to-bond plastics: effective on PE, PP, PTFE and more.
-
Fast & clear: sets in seconds, dries transparent for nearly invisible repairs.
-
Durable: water-resistant and suitable for cold conditions.
Surface Preparation
- Ensure both surfaces are clean, dry and close-fitting. Remove grease, oil, dust or loose particles.
- For best adhesion on very smooth plastics, lightly roughen with fine-grade sandpaper and wipe clean.
- Avoid use on soft foams, expanded polystyrene or highly porous materials.
- Always test on a small, inconspicuous area if unsure about compatibility.
Application Instructions
-
Prime with activator: Apply one or two thin coats to both bonding surfaces, ensuring full coverage. Re-cap the activator pen immediately. Allow to dry/react for 1–2 minutes.
-
Apply adhesive: Place a minimal drop of glue on one surface only. Bring parts together immediately and hold firm pressure for at least 1 minute. Avoid shifting once contact is made.
-
Cure: Leave undisturbed for 10 minutes. Full bond strength develops after 12–24 hours at room temperature.
Coverage & Performance
Only a thin film is required—one drop bonds most small mating areas. Initial handling strength is typically achieved within 5–30 seconds depending on substrates and conditions.
Drying & Setting Time
-
Initial set: 5–30 seconds*
-
Handling time: ~1 minute
-
Full cure: 12–24 hours
-
Recommended conditions: 15–30 °C and ≥30% relative humidity
*Setting and cure times vary with substrate, joint fit, temperature and humidity.
Clean-Up & Storage
- Wipe nozzle to remove excess adhesive and replace caps immediately after use.
- Store upright in a cool, dry place away from sunlight and moisture. Do not refrigerate.
- Shelf life (unopened and properly stored): up to 18 months.
Limitations
- Not recommended for glass, very flexible materials, soft foams or highly porous substrates.
- Not suitable for continuous water immersion or high-heat applications.
- For indoor use or dry environments; test before critical repairs.
Safety & Handling
- Contains cyanoacrylate. Bonds skin and eyes in seconds. Avoid contact.
- Use in a well-ventilated area; consider gloves and eye protection.
- If skin is bonded, do not pull apart—soak in warm, soapy water and gently roll/separate. Acetone may assist on non-sensitive skin; avoid on plastics.
- If in eyes, rinse cautiously with water and seek medical attention immediately.
- Keep out of reach of children.
Technical Data
| Product Type |
Two-part system: Activator + Cyanoacrylate Adhesive |
| Substrates |
PE, PP, PTFE, many rigid plastics, rubber, selected metals |
| Appearance |
Clear (dries transparent) |
| Packaging Size |
2 g adhesive + 4 ml activator |
| Initial Set |
5–30 seconds (substrate dependent) |
| Full Cure |
12–24 hours at ambient conditions |
| Temperature Range |
Approx. −50 °C to +80 °C (typical for cured cyanoacrylates) |
| Cleanup |
Mechanical removal once cured; avoid solvents on sensitive plastics |
What’s Included
- LOCTITE Super Glue (2 g)
- Surface Activator Pen (4 ml)
