Description
Selleys Liquid Nails Instant Hold is a high performance advanced polymer construction adhesive that delivers an instant hold on any building material*, even vertical surfaces. It is heat, UV and water resistant and doesn’t require fasteners or clamps for many applications so you can get on with the next job. Powered by Sil-X Advanced Polymer Technology.
Features
Instant Hold on any building material*
Up to 400kgs M2
No need to clamp*
High Strength & flexibility
Indoor/Outdoor
Adheres to wet and damp surfaces and can be applied on wet surface^
Cure time of 48 hours
Paintable after 24 hours with water based paints. Solvent based paints may be used after first painting with a water based paint
Adjustable e.g. can be straightened for up to 15 minutes
Powered by Sil-X Advanced Polymer Technology
*Holds instantly but must not be disturbed until fully cured. Weight is restricted for non-porous substrates including metal & glass – support may be required where the object exceeds 5kgs.
^Not for permanent water immersion
What Materials is this product suitable for?
Timber
MDF
Plasterboard
Some plastics Masonry
Concrete
Particleboard
Metals
Glass
Tiles & ceramics
How to use the product
Ensure surfaces are clean and free from grease or loose particles
Use a high thrust caulking gun and the supplied V-notch nozzle to apply in vertical stripes 5cm apart. Ensure the V shape is angled upward when applying.
Position materials and press together firmly. Due to the high initial hold of the product support during curing is not necessary (subject to weight limitations for non-porous surfaces).
Holds instantly but must not be disturbed until cured (up to 48 hours).
Adjustable e.g. can be straightened for up to 15 minutes
Handy Tips
Clean up with turps before the adhesive cures
Safety Information
KEEP OUT OF REACH OF CHILDREN.
Avoid skin and eye contact and breathing vapours.
Use in a well ventilated area.
Wash hands after use.
If on skin: Wash with soap and water.
Product releases methanol during cure. Refer to Safety Data Sheet.
Storage & re-use
Cure product before disposal
Store in a cool place.
The adhesive should be used within 6 months after opening.
If the adhesive is going to be used again within a few days, leave the nozzle on and merely extrude approximately 2 cm of product before storing the cartridge upright. This will cure to a plug which can easily be pulled out when required.
For longer storage periods, leave the nozzle on and place a piece of plasticene or Blu Tack over the end of the nozzle. Tightly tape a piece of aluminium foil over the whole nozzle to exclude any air.
When you want to re-use the product, simply take off the foil and plug from the old nozzle pull out the excess adhesive from the nozzle with a corkscrew, then re-pierce any cure at the tip of the cartridge and re-use.
If cure has taken place into the cartridge, the product is unlikely to be in a useable state and should be disposed.
