Description
This acrylic-based Industrial Strength product dispenses resin and hardener automatically into equal parts with one push. Hold surfaces together with clamp, tape or weights allowing 5-10 minutes setting time. Works well on plastic toys, fixtures made of plastic, metal, concrete and many other materials. Cures to an opaque light yellow colour.
Works best on:
Plastics
Metal
Concrete
Glass
Ceramics
China
Properties:
Initial colour: Light yellow to amber
Final colour: Light yellow
Positioning Time: 3 – 5 minutes
Set Time: 5-10 minutes @ 65-80F
Handling Time: 2 hours
Full Strength: 24 hours
Instructions: (Note: not recommended for polyethylene or polypropylene bonding).
1. Surfaces should be clean and dry, free from oil and grease.
2. Roughen surfaces with emery cloth or sandpaper & wipe clean with a solvent for best results.
3. Dispense from the syringe and mix thoroughly approximately 1 minute.
4. Apply to both surfaces and mate parts together.
5. Remove excess glue immediately with denatured alcohol.
6. Sets in 5-10 minutes at room temperature (77F or 25C) with full cure in 24 hours.
Storage:
After use, pull back on the plunger, wipe tips to remove residual product and reseal with plug. Store product sealed, with tips up, in a cool, dry location. Stored under these conditions, a one-year shelf life can be expected.
Safety
WARNING: FLAMMABLE. Eye and skin irritant. Contains Methyl methacrylate. May cause sensitization by skin contact. Refer to the Safety Data Sheet (SDS) for full details.
