Loxeal Superlox Polyolefin Bonder 25ml Bi-Syringe (Single)
Loxeal Superlox is a two-part acrylic adhesive developed to bond polyolefins, polypropylene (PP), polyethylene (PE), HDPE and LDPE, and other notoriously difficult low-surface-energy plastics, without primers, flame treatment or other expensive surface pre-treatments. This listing is for a single 25ml bi-syringe supplied with a mixing nozzle, dispensing the two components at a simple 1:1 ratio, so you can buy just what one job needs. It joins polyolefins to each other and to other plastics such as ABS and PVC, and to metals, producing structural joints with high shear and peel strength.
Why choose Loxeal Superlox?
-
Bonds the "unbondable", PP, PE, HDPE and LDPE plus other low-surface-energy plastics
-
No primer or surface pre-treatment required, clean, apply, assemble
-
Single 25ml bi-syringe with mixing nozzle, fresh adhesive for the job at hand
-
Simple 1:1 mixing ratio through the supplied static mixing nozzle
-
Structural performance, high shear and peel strength on plastics and mixed-material joints
- Also bonds polyolefins to other plastics (ABS, PVC) and to metals
Typical applications
- Repairing and fabricating PP and PE components: tanks, housings, containers, piping and trim
- Joining polyolefin parts to dissimilar plastics or metal brackets and fittings
- Manufacturing and maintenance work on low-surface-energy plastic assemblies
How to use
- Clean the surfaces to remove dust, oil and grease (for example with Loxeal Cleaner 10) and allow to dry.
- Fit the static mixing nozzle to the bi-syringe and discard the first few centimetres of extruded adhesive.
- Apply the mixed adhesive to one surface.
- Assemble the parts promptly and hold or clamp them without movement while the adhesive sets.
- Leave the joint undisturbed until fully cured before applying load.
Cure times
- Fast curing at room temperature, parts typically fixture within minutes of assembly
- Allow 24 hours for full strength before placing joints under working load
- Refer to the Technical Data Sheet for precise fixture and cure data for your conditions
Specifications
| Chemistry |
Two-part structural acrylic, polyolefin bonder |
| Mixing ratio |
1:1 by volume via static mixing nozzle |
| Key substrates |
PP, PE, HDPE, LDPE and other low-surface-energy plastics; also ABS, PVC and metals |
| Surface preparation |
No primer or pre-treatment required, clean and dry surfaces only |
| Strength profile |
High shear and peel strength |
| Pack size |
1 x 25ml bi-syringe with mixing nozzle |
Buying more than one?
If you use Superlox regularly, the Superlox trade pack of 10 x 25ml bi-syringes works out cheaper per syringe.
Important notes
- Work at room temperature; low temperatures slow the cure
- Use each mixing nozzle for one continuous application, fit a fresh nozzle if work is interrupted
- Cured adhesive can only be removed mechanically
- Store in a cool, dry place at no more than +25°C
Safety
Consult the Safety Data Sheet (SDS) before use. Use in a well-ventilated area and avoid skin and eye contact.
Product information is provided as a general guide only. Always refer to the manufacturer's Technical Data Sheet and Safety Data Sheet, and test the product for suitability in your specific application before use.
