Loxeal Activator 11 Anaerobic Accelerator Spray 200ml
Loxeal Activator 11 cleans, degreases and dramatically accelerates the cure of anaerobic adhesives and sealants – threadlockers, threadsealants, retaining compounds and gasketing products. It is the answer when anaerobic products cure slowly or unreliably: on passive surfaces (such as stainless steel, plated finishes and many alloys), at low temperatures, or across larger gaps. Spray one surface, let the solvent flash off for a few seconds, and fixture is typically achieved in 20–120 seconds. Supplied as a 200ml aerosol for fast, even coverage.
Why choose Loxeal Activator 11?
-
Speeds anaerobic fixture time to 20–120 seconds depending on adhesive, gap and temperature
-
Cleans and degreases the joint in the same step
-
Reliable curing in tough conditions – passive metals, cold workshops, larger gaps
-
Long-lasting activation – treated parts remain active for up to three months when protected from dust and weathering
- Suitable for both threaded and flange joints
- Convenient 200ml aerosol spray application
Typical applications
- Pre-treating stainless steel, zinc-plated and other passive fasteners before threadlocking or threadsealing
- Accelerating retaining compounds on bearings, bushes and cylindrical assemblies
- Speeding gasket and flange sealant cure in cold conditions or production settings
How to use
- Spray Activator 11 onto one of the surfaces to be joined.
- Allow the solvent to evaporate for a few seconds until the surface is dry.
- Apply the anaerobic adhesive or sealant to the other surface.
- Assemble the parts; fixture typically occurs within 20–120 seconds.
Specifications
| Composition |
Organic activating agents in solvent carrier |
| Appearance |
Green liquid |
| Viscosity (+25°C) |
1–2 mPa·s |
| Specific weight (+25°C) |
0.8 g/ml |
| Flash point (COC/DIN/ISO 2592) |
+21°C |
| Cure acceleration |
Fixture in 20–120 seconds (adhesive, gap and temperature dependent) |
| On-part activation life |
24 hours; up to 3 months if parts are protected from dust and atmospheric agents |
| Breakaway torque (ISO 10964, ref. 83-54) |
>5 Nm after 5 minutes |
| Pack size |
200ml aerosol spray |
| Shelf life |
1 year unopened at +25°C |
Important notes
- Use of an activator may reduce the final mechanical strength of the anaerobic bond
- Wait for the solvent to fully evaporate before assembling parts
- Flammable – keep away from ignition sources and use with good ventilation
- Store in a cool, dry place at no more than +25°C; do not refill containers with used product
Safety
Consult the Safety Data Sheet (SDS) before use. Flammable aerosol: keep away from heat, sparks and open flames, use in a well-ventilated area and avoid inhaling vapours.
Product information is provided as a general guide only. Always refer to the manufacturer's Technical Data Sheet and Safety Data Sheet, and test the product for suitability in your specific application before use.
